Chapter 5 219
Language Reference
FETCh Subsystem
FETCh Subsystem
The FETCh? commands are used with several other commands to
control the measurementprocess. These commands are described in the
section on the “MEASure Group of Commands” on page 233.
Fetch the Current Measurement Results
:FETCh:<measurement>[n]?
A FETCh? command must specify the desired measurement. It will
return the valid results that are currently available, but will not
initiate the taking of any new data. You can only fetch results from the
measurement that is currently selected. The code number n selects the
kind of results that will be returned. The available measurements and
data results are described in the “MEASure Group of Commands” on
page 233.
To Next Page
Loading...
Need help?
General
