Agilent Technologies E4406A VSA Series - RF Port Power Range Auto

308 Chapter5
Language Reference
SENSe Subsystem
RF Port Power Range Auto
[:SENSe]:POWer[:RF]:RANGe:AUTO OFF|ON|0|1
[:SENSe]:POWer[:RF]:RANGe:AUTO?
Select the RF port power range to be set either automatically or
manually.
On - power range is automatically set as determined by the actual
measured power level at the start of a measurement.
Off - power range is manually set
Factory Preset
and *RST: On
Remarks: You must be in the cdmaOne, EDGE(w/GSM), GSM,
NADC, PDC, cdma2000, W-CDMA (3GPP), or W-CDMA
(Trial & Arib) mode to use this command. Use
INSTrument:SELect to set the mode.
Front Panel
Access:
Input, Max Total Pwr (at UUT)