Chapter 5 225
Language Reference
HCOPy Subsystem
Page Orientation
:HCOPy:PAGE:ORIentation LANDscape|PORTrait
:HCOPy:PAGE:ORIentation?
Specifies the orientation of the print image.
NOTE Landscape mode is not presently supported for PCL-3 printers.
Factory Preset
and *RST: Portrait. This parameter is persistent, which means
that it retains the setting previously selected, even
through a power cycle.
History: Revision A.04.00 and later
Front Panel
Access:
Print Setup, Orientation with Print To:Printer selected
Number of Items Printed on a Page
:HCOPy:PAGE:PRINts 1|2
:HCOPy:PAGE:PRINts?
Sets the number of display print outputs sent to print on one sheet of
paper, before a form feed is sent.
Factory Preset
and *RST: 1. This parameter is persistent, which means that it
retains the setting previously selected, even through a
power cycle.
History: Revision A.04.00 and later
Remarks: This must be set to 1 if the paper orientation is
landscape.
Front Panel
Access: Print Setup, Prints/Page with Print To:Printer selected
To Next Page
Loading...
