280 Chapter5
Language Reference
SENSe Subsystem
Adjacent Channel Power—Select Sideband
[:SENSe]:ACP:OFFSet:LIST:SIDE BOTH|NEGative|POSitive,
BOTH|NEGative|POSitive, BOTH|NEGative|POSitive,
BOTH|NEGative|POSitive, BOTH|NEGative|POSitive
[:SENSe]:ACP:OFFSet:LIST:SIDE?
Selects which sideband will be measured. You can turn off (not use)
specific offsets with the SENS:ACP:OFFSet:LIST:STATe command.
Factory Preset
and *RST:
Remarks: You must be in Basic or cdmaOne mode to use this
command. Use INSTrument:SELect to set the mode.
Adjacent Channel Power—Control Offset Frequency List
Basic mode, cdmaOne
[:SENSe]:ACP:OFFSet:LIST:STATe OFF|ON|0|1, OFF|ON|0|1,
OFF|ON|0|1, OFF|ON|0|1, OFF|ON|0|1
[:SENSe]:ACP:OFFSet:LIST:STATe?
cdma2000, W-CDMA (3GPP) mode
[:SENSe]:ACP:OFFSet[n]:LIST:STATe OFF|ON|0|1, OFF|ON|0|1,
OFF|ON|0|1, OFF|ON|0|1, OFF|ON|0|1
[:SENSe]:ACP:OFFSet[n]:LIST:STATe?
cdmaOne, W-CDMA (Trial & Arib) mode
[:SENSe]:ACP:OFFSet[n]:LIST[n]:STATe OFF|ON|0|1,
OFF|ON|0|1, OFF|ON|0|1, OFF|ON|0|1, OFF|ON|0|1
[:SENSe]:ACP:OFFSet[n]:LIST[n]:STATe?
Selects whether testing is to be done at the custom offset frequencies.
The measured powers are tested against the absolute values defined
with[:SENSe]:ACP:OFFSet[n]:LIST[n]:ABSolute,or the relative values
defined with [:SENSe]:ACP:OFFSet[n]:LIST[n]:RPSDensity and
[:SENSe]:ACP:OFFSet[n]:LIST[n]:RCARier.
Offset[n] n=1 is base station and 2 is mobiles. The default is base
station (1).
List[n]
Mode Offset A Offset B Offset C Offset D Offset E
Basic &
cdmaOne
Both Both Both Both Both
To Next Page
Loading...
