284 Chapter5
Language Reference
SENSe Subsystem
Defines the type of testing to be done at any custom offset frequencies.
The measured powers are tested against the absolute values defined
with[:SENSe]:ACP:OFFSet[n]:LIST[n]:ABSolute,or the relative values
defined with [:SENSe]:ACP:OFFSet[n]:LIST[n]:RPSDensity and
[:SENSe]:ACP:OFFSet[n]:LIST[n]:RCARrier.
You can turn off (not use) specific offsets with the
[:SENS]:ACP:OFFSet[n]:LIST[n]:STATe command.
Offset[n] n=1 is base station and 2 is mobiles. The default is base
station (1).
List[n]
cdmaOne mode n=1 is cellular bands and 2 is pcs bands. The default is
cellular.
W-CDMA (Trial
& Arib) mode n=1 is ARIB, 2 is 3GPP, and 3 is Trial. The default is
ARIB (1).
The types of testing that can be done for each offset include:
• Absolute - Test the absolute power measurement. If it fails, then
return a failure for the measurement at this offset.
• And - Test both the absolute power measurement and the power
relative to the carrier. If they both fail, then return a failure for the
measurement at this offset.
• Or - Test both the absolute power measurement and the power
relative to the carrier. If either one fails, then return a failure for the
measurement at this offset.
• Relative - Test the power relative to the carrier. If it fails, then
return a failure for the measurement at this offset.
Factory Preset
and *RST:
Mode Variant Offset A Offset B Offset C Offset D Offset E
iDEN REL n/a n/a n/a n/a
Basic REL REL REL REL REL
cdmaOne BS cellular REL REL REL REL REL
BS pcs REL ABS ABS REL REL
MS cellular REL REL REL REL REL
MS pcs REL ABS ABS REL REL
cdma2000 REL REL REL REL REL
To Next Page
Loading...
Need help?
General
