Alcatel-Lucent OmniSwitch 6800 Series - Page 917

OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008 page -5
GVRP
application examples 6-5
display configuration on specified port 6-13
specifications 6-2
gvrp applicant command 6-10
gvrp enable-vlan-advertisement command 6-12
gvrp enable-vlan-registration command 6-11
gvrp maximum vlan command 6-8
gvrp portcommand 6-5
gvrp registration command 6-9
gvrp static-vlan restrictcommand 6-5
GVRP Timers 6-10
gvrp transparent switchingcommand 6-8
gvrpcommand 6-5
H
health interval command 9-10, 23-45
health statistics reset command 23-47
health threshold command 23-43
health threshold limits
displaying 23-44
Hot Standby Routing Protocol
see HSRP
Hsecu.img 14-8
HSRP
not compatible with VRRP 11-3
I
ICMP 6-28
control 6-31
QoS policies for 18-61
statistics 6-31
icmp messages command 6-30
icmp type command 6-29, 6-30
IEEE 3-1
IGMP
multicast ACLs 19-1, 19-14
IGMP Spoofing 20-19
Institute of Electrical and Electronics Engineers
see IEEE
interfaces admin command 25-9
interfaces alias command 25-12
interfaces autoneg command 25-16
interfaces crossover command 25-17
interfaces duplex command 25-15
interfaces flood multicast command 25-10, 25-11
interfaces flood rate command 25-11
interfaces hybrid autoneg command 25-22
interfaces hybrid crossover command 25-23
interfaces hybrid duplex command 25-21
interfaces hybrid forced-copper command 25-19
interfaces hybrid forced-fiber command 25-18
interfaces hybrid preferred-copper command 25-19
interfaces hybrid preferred-fiber command 25-20
interfaces hybrid speed command 25-20
interfaces ifg command 25-15
interfaces max frame command 25-13
interfaces no l2 statistics command 25-9
interfaces speed command 25-14
inter-frame gap value 25-15
Internet Control Message Protocol
see ICMP
Internet Packet Exchange
see IPX
interswitch protocols
AMAP 2-1, 2-3
application examples 2-8
defaults 2-2
specifications 2-2
IP 6-1
application examples 6-4
ARP 6-12
defaults 6-2
directed broadcast 6-22
ICMP 6-28
ping 6-31
protocols 6-5
router ID 6-15
router port 6-8
router primary address 6-15
specifications 6-2
static route 6-11, 7-16
tracing an IP route 6-32
TTL value 6-16
UDP 6-32
verify information about 6-35
ip access-list address command 8-15
ip access-list command 8-15
ip default-ttl command 6-16
ip directed-broadcast command 6-22
ip dos scan close-port-penalty command 6-25
ip dos scan decay command 6-26
ip dos scan tcp open-port-penalty command 6-25
ip dos scan threshold command 6-26
ip dos scan udp open-port-penalty command 6-25
ip dos trap command 6-26
ip helper address command 10-9, 14-30
ip helper avlan only command 10-11, 14-30
ip helper boot-up command 10-12
ip helper forward delay command 10-10
ip helper maximum hops command 10-11
ip helper per-vlan command 10-11
ip helper standard command 10-11
ip interface command 8-3
configuring authenticated VLANs 14-26
ip load rip command 8-3, 8-6
ip multicast igmp-proxy-version command 20-10, 20-24
ip multicast neighbor-timeout command 20-10, 20-16,
20-17, 20-18, 20-24, 20-31
ip multicast query-interval command 20-14, 20-15, 20-28
ip multicast static-member command 20-12
ip multicast static-neighbor command 20-25
ip multicast static-querier command 20-12
IP Multicast Switching
see IPMS
ip multicast switching command 20-9, 20-19, 20-23, 20-33
IP multinetting 6-7