Alcatel-Lucent OmniSwitch 6800 Series - Page 916

page -4 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
DNS
URL for Web browser authentication clients 14-8
DoS 6-22
enabling traps 6-26
setting decay value 6-26
setting penalty values 6-25
Setting Port Scan Penalty Value 6-26
DSCP
trusted ports 18-27
DVMRP 20-8
defaults 6-2
dynamic link aggregation 5-1
application examples 5-4, 5-29
defaults 5-3
group actor administrative key 5-15
group actor system ID 5-16
group actor system priority 5-16
group administrative state 5-15
group partner administrative key 5-17
group partner system ID 5-18
group partner system priority 5-17
groups 5-11
assigning ports 5-12
creating groups 5-11
deleting groups 5-11
group names 5-14
removing ports 5-13
LACPDU bit settings 5-19, 5-23
LACPDU frames 5-19, 5-23
Link Aggregation Control Protocol (LACP) 5-7
MAC address 5-16, 5-18, 5-20, 5-25
port actor administrative priority 5-21
port actor port priority 5-22
port actor system administrative states 5-19
port actor system ID 5-20
port partner administrative key 5-25
port partner administrative priority 5-27
port partner administrative state 5-23
port partner administrative system ID 5-25
port partner administrative system priority 5-26
port partner port administrative status 5-27
ports 5-12
specifications 5-2
verify information about 5-32
dynamic log
LDAP accounting servers 13-26
dynamic VLAN port assignment
mobile ports 11-4
secondary VLANs 11-13
VLAN rules 13-1
E
errors 24-8
Ethernet
application examples 25-24
defaults 25-2, 25-3
flood rate 25-10
frame size 25-13
full duplex 25-15, 25-21
half duplex 25-15, 25-21
multicast traffic 25-11
specifications 25-2
verify information 25-26
Ethernet OAM
application example 9-6
configuration 9-7
Connectivity Fault Management 9-3
Alarm Indication Signal Messages 9-4
Continuity Check Messages 9-4
Link Trace Messages 9-4
Loop-back Messages 9-4
defaults 9-2
overview 9-3
specifications 9-2
verification 9-11
ethoam association ccm-interval command 9-8
ethoam association command 9-6
ethoam association mhf command 9-7, 9-8, 9-9
ethoam association-default command 9-8
ethoam domain command 9-6
ethoam end-point command 9-6
ethoam intermediate-point command 9-6
ethoam linktrace command 9-9
ethoam loopback command 9-9
F
Fast Ethernet
see Ethernet
Fast Spanning Tree 8-6
filtering lists
see ACLs
filters
IPX GNS 12-13
IPX RIP 12-12
IPX SAP 12-12
forced copper 25-4
configuring 25-19
forced fiber 25-4
configuring 25-18
frame type 3-6
G
GARP
active member 6-3
messages 6-3
passive member 6-3
Generic Attribute Registration Protocol
see GARP
Gigabit Ethernet
see Ethernet