5 - 50
DRIVE SHAFT INSTALLATION
Once the drive shaft has been inserted, proceed to assemble
the big end Fig. B.
Tighten the nuts to the following torque:
T
.
R
.
Torque 25 N*m
NOTE:_________________________________
Lubricate the big end pins with copper grease
Measure:
Once the big end has been assembled, use a thickness gauge
to measure the drive shaft-big end collar Fig. C.
Measuring Size
Drive shaft - steering head 0.1~0.25 mm
NOTE:_________________________________
Measure both big ends.
B
C
CRANKCASE
COPY - Moto GB - Grant Martland - grantmartland@motogb.co.uk
To Next Page
Loading...
