EasyManuals Logo

Benelli TRK 502 Service Station Manual

Benelli TRK 502
408 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #92 background imageLoading...
Page #92 background image
3 - 56
ELECTRICAL SYSTEM
SUBSTITUTION OF THE REAR INDICATOR LIGHTS
Place the motorcycle on a at, level oor.
IMPORTANT NOTICE
Prop the motorcycle on suitable supports so that it cannot
fall.
NOTE:_________________________________
The following procedure is applicable to both rear indicators.
Remove:
Rider and passenger seats, refer to chapter “Removal of
rider and passenger seats, Chapter 4”.
Rear handles, refer to chapter “Removal of the rear han-
dles, Chapter 4”.
Side fairings, refer to chapter “Removal of the side fair-
ings, Chapter 4”.
Disconnect:
the indicator cables
Remove the nuts of the rear indicator supports (E) Fig. D
Remove the indicators and substitute them with the new
ones.
Install:
Proceed in the reverse order of removal.
D
D
E
COPY - Moto GB - Grant Martland - grantmartland@motogb.co.uk

Table of Contents

Other manuals for Benelli TRK 502

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Benelli TRK 502 and is the answer not in the manual?

Benelli TRK 502 Specifications

General IconGeneral
Displacement500 cc
Transmission6-speed
Fuel Tank Capacity20 liters
Seat Height800 mm
Wet Weight235 kg
Bore x Stroke69 mm x 66.8 mm
Compression Ratio11.5:1
ClutchWet multi-plate
FrameSteel trellis
Wheelbase1505 mm
Ground Clearance190 mm
Max Power47.6 hp (35 kW) @ 8500 rpm
Max Torque46 Nm @ 6000 rpm
Front Suspension50 mm upside-down fork
Front BrakeDouble floating discs, 320mm, 4-piston calipers
Rear BrakeSingle 260 mm disc
Fuel SystemElectronic Fuel Injection (EFI)
ABSDual-channel ABS
Front Tire120/70 R17
Rear Tire160/60 R17
Engine TypeLiquid-cooled, four-stroke, parallel twin cylinder, DOHC, 4 valves per cylinder

Related product manuals