EasyManuals Logo

Benelli TRK 502 Service Station Manual

Benelli TRK 502
408 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
3 - 40
ELECTRICAL SYSTEM
BATTERY CHECK AND CHARGING
WARNING
The batteries produce a nitrogen-based explosive gas and
contain electrolyte, which is composed of sulfuric acid, a
poisonous substance and highly caustic.
The following precautions should be always observed:
Wear protective goggles when handling a battery or while
working nearby.
Recharge the batteries in a suitably ventilated area.
Battery must be far away from re, sparks or open ames
(e.g., welding equipment, lighted cigarettes, etc.).
DO NOT SMOKE during recharging or handling of the bat-
tery.
PUT BATTERIES AND ELECTROLYTE BEYOND THE REACH
OF CHILDREN.
Do not allow electrolyte to come into contact with body parts
to prevent severe burns or permanent injury to eyes.
FIRST AID IN THE EVENT OF CONTACT:
EXTERNAL CONTACT
Skin: wash with water.
Eyes: Wash with water jets for 15 minutes and seek imme-
diate medical attention.
SWALLOWING
Drink large quantities of water or milk, milk of magnesia,
beaten egg or vegetal oil. Seek immediate medical atten-
tion.
IMPORTANT NOTICE
This battery is sealed. Do not remove the sealing caps in any
case, to preserve the equilibrium between the cells and not
to affect the battery performance.
The time, the amperage, and the voltage for recharging the
battery differ from the standard ones. Recharge the battery
as shown in the gures. If the battery is overcharged, the
electrolyte level drops signi cantly. Therefore, during re-
charging, pay the utmost attention.
NOTE:_________________________________________
As the battery is sealed, the recharging state cannot be
checked by measuring the electrolyte density.
Therefore, check battery charging by measuring the voltage
on the battery terminals.
Remove:
Rider and passenger seats, see chapter “Removal of rider
and passenger seats, Chapter 4”.
Disconnect:
COPY - Moto GB - Grant Martland - grantmartland@motogb.co.uk

Table of Contents

Other manuals for Benelli TRK 502

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Benelli TRK 502 and is the answer not in the manual?

Benelli TRK 502 Specifications

General IconGeneral
Displacement500 cc
Transmission6-speed
Fuel Tank Capacity20 liters
Seat Height800 mm
Wet Weight235 kg
Bore x Stroke69 mm x 66.8 mm
Compression Ratio11.5:1
ClutchWet multi-plate
FrameSteel trellis
Wheelbase1505 mm
Ground Clearance190 mm
Max Power47.6 hp (35 kW) @ 8500 rpm
Max Torque46 Nm @ 6000 rpm
Front Suspension50 mm upside-down fork
Front BrakeDouble floating discs, 320mm, 4-piston calipers
Rear BrakeSingle 260 mm disc
Fuel SystemElectronic Fuel Injection (EFI)
ABSDual-channel ABS
Front Tire120/70 R17
Rear Tire160/60 R17
Engine TypeLiquid-cooled, four-stroke, parallel twin cylinder, DOHC, 4 valves per cylinder

Related product manuals