Benelli TRK 502 Service Station Manual

5 - 74
GEAR BOX
GEAR BOX ASSEMBLY
Check:
that the end of the gear lock spring (2*) is in its seat on the
selector (*1) plate.
Check:
that in the neutral position, the clearance between the two ends
of the spring and the strike pin is “0” Fig. O
Assemble:
• the gear shaft as in Fig. O
Position
• the gear (2)
• the drive shaft gear (1), locking it into place with the spline
(3) Fig. Q
Install:
• the guide bushing (5)
• the counter shaft gear (6)
• the spline (7) Fig. R
NOTE:________________________________
Bring the two shaft phasing points into line and check the
drive shaft Fig. S
O
2*
1*
“0”
Q
R
1
2
3
5
6
7
4
S
COPY - Moto GB - Grant Martland - grantmartland@motogb.co.uk

Benelli TRK 502 Specifications

General

Displacement	500 cc
Transmission	6-speed
Fuel Tank Capacity	20 liters
Seat Height	800 mm
Wet Weight	235 kg
Bore x Stroke	69 mm x 66.8 mm
Compression Ratio	11.5:1
Clutch	Wet multi-plate
Frame	Steel trellis
Wheelbase	1505 mm
Ground Clearance	190 mm
Max Power	47.6 hp (35 kW) @ 8500 rpm
Max Torque	46 Nm @ 6000 rpm
Front Suspension	50 mm upside-down fork
Front Brake	Double floating discs, 320mm, 4-piston calipers
Rear Brake	Single 260 mm disc
Fuel System	Electronic Fuel Injection (EFI)
ABS	Dual-channel ABS
Front Tire	120/70 R17
Rear Tire	160/60 R17
Engine Type	Liquid-cooled, four-stroke, parallel twin cylinder, DOHC, 4 valves per cylinder