Brother MFC-8220 - Page 116

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
4-38
NOTE:
When re-assembling the thermistor to the FU frame upper, ensure the direction of the
thermistor is correct referring to the figure below;
Fig. 4-67
(8) Remove the two cup B M3x20 Taptite screws from the FU frame upper.
(9) Release the hooks, and then remove the FU frame upper from the FU frame lower.
Fig. 4-68
Thermistor
Thermistor
Taptite, cup B M3x12
FU frame upper
FU frame lower
Hook
Hook
Pin
FU frame upper
Hook
Pin
Hook
Taptite, cup B M3x20
Taptite, cup B M3x20