Brother MFC-8220 - Page 117

MFC-8220
SERVICE MANUAL
4-39
(10) Remove the two pan (S/P washer) M26x8 Taptite screws.
(11) Remove the heat roller 25.
(12) Remove the halogen lamp.
Fig. 4-69
NOTE:
When re-assembling the halogen lamp, ensure that the direction of the halogen lamp is
correct referring to the figure above.
!
CAUTION:
• Never touch the surface of the halogen lamp.
• When securing the screw to assemble the halogen lamp connector plate, ensure you use
the Fu lamp assembly jig ASSY as shown in the figure below to avoid damaging the edge
of the halogen lamp.
Fig. 4-70
Screw, pan (S/P washer) M26x8
Fu lamp assembly jig ASSY
Halogen lamp connector plate
Halogen lamp
Screw, pan
(S/P washer) M26x8
Heat roller 25
FU frame upper
Heat roller 25
Halogen lamp
Halogen lamp
connector plate
Screw, pan (S/P washer)
M26x8
Halogen lamp
Colored side
115V:Orange
220V:Black
Washer, plain 26
Washer, plain 26
Washer, plain 26