176
Chapter 9
10. When setting the dancer arm, the Nyloc nut at the end of the dancer arm should
be in what position relative to the edge of the ribbon tension plate as the cam
follower contacts the brake arm?
a) Even with
b) 1 inch in front
c) 1 inch behind
d) This setting doesn’t matter
Operator Test Key
1. (a) True 2. (b) 1-2 inches 3. (b) The Thread button 4. (a) Top 5. (a) Ribbon Drop
Mechanics Test Key
1. (a) Upper and/or lower bag-stop worn out 2. (c) Slick or are scalloping with black showing
through the red 3. (a) Name of motor involved 4. (c) Fuse, Prox, Motor, Encoder 5. (a)
True 6. (a) True 7. (d) Left/Right hand select 8. (c) .25 inches 9. (d) 3/32 inch 10. (a)
Even with
To Next Page
Loading...
