Canon imagePROGRAF IPF720 - Detection of the Remaining Roll Paper

Handling rolls
Detection of the Remaining Roll Paper
If you have activated automatic detection of the remaining roll paper , when the roll is ejected, a barcode with text is
printed on the roll paper that identies the type of paper and amount left. If this function is activated and barcodes
are printed on the roll paper , the type of paper and amount left are automatically detected when you load a
roll. The barcode will be cut of f after it has been read.
Note
• If the document is not cut but kept in the printer , only the text message is printed. This is also the
case when printing on 8-inch rolls or clear lm.
Important
• If the barcode is not detected when it is advanced, enter the type and length of paper on the Control
Panel.
• Barcodes are not cut of f when Chk Remain.Roll and T rim Edge First are both Off . T o have the printer
cut of f barcodes automatically , on the Control Panel menu, set Chk Remain.Roll to On . Otherwise cut
of f barcodes by using Paper Cutting in the Control Panel menu.
Follow these steps to activate detection of the remaining roll paper .
1. Press the Menu button to display MAIN MENU .
2. Press ▲ or ▼ to select Media Menu , and then press the ► button.
3. Press ▲ or ▼ to select Chk Remain.Roll , and then press the ► button.
4. Press ▲ or ▼ to select the desired setting option, and then press the OK button.
Handling Paper 1 19