Canon imagePROGRAF IPF720 - Cannot Adjust Band; Messages Regarding Printing or Adjusment; Use Another Paper

Messages regarding printing or adjusment
Messages regarding printing or adjusment
Use another paper .
Cause Corrective Action
W e recommend using a type of paper that you often
use, other than lm, for Printhead adjustment.
( → P .491)
The Printhead and feed amount cannot be adjusted
when highly transparent lm is loaded.
Adjust the feed amount manually .
( → P .501)
Cannot print as specied.
Lift the release lever and replace paper with A4/L TR (vertical) or larger
Cause Corrective Action
The loaded paper is too small. Switch to paper A4/Letter (vertical) or larger .
Lift the release lever and replace roll with 10 in. wide or larger roll
Cause Corrective Action
The loaded paper is too small. Load a roll 10 inches wide or larger .
Cannot adjust band.
Cause Corrective Action
The Printhead nozzles are clogged. Follow the steps below to check the nozzles.
1. Print a test pattern to check the nozzles.
( → P .516)
2. Clean the Printhead if the nozzles are clogged.
( → P .517)
Highly transparent lm is loaded that cannot be used
for feed amount adjustment.
Adjust the feed amount manually .
( → P .501)
Cannot adjust printhead.
Cause Corrective Action
The Printhead nozzles are clogged. Follow the steps below to check the nozzles.
1. Print a test pattern to check the nozzles.
( → P .516)
2. Clean the Printhead if the nozzles are clogged.
( → P .517)
Highly transparent lm is loaded that cannot be used
for Printhead adjustment.
W e recommend using a type of paper that you often
use, other than lm, for Printhead adjustment.
( → P .491)
Error Message 587