Cutter Unit
6. Hold the Cutter Unit by the grip (a). Pushing down at the position indicated (b), remove it from
the Carriage .
Important
• Never touch any part of the Cutter Unit except the grips (a) and (b). This poses a risk of injury and
may stain your hands. Also, it may damage the printer .
Caution
• Dispose of the used Cutter Unit according to local regulations.
• Do not disassemble the Cutter Unit . T ouching the blade may cause injury .
7. Hold the new Cutter Unit by the grip (a). Pushing down at the position indicated (b), attach it to
the Carriage until it clicks into place.
8. Close the T op Cover .
The Carriage moves into position and a conrmation message is displayed regarding resetting
the cut counter .
9. Press the OK button.
The printer now goes online.
Maintenance 527
To Next Page
Loading...
