Printing procedure
9. Send the print job.
• Printing from Windows (→P .89)
• Printing from Mac OS X (→P .90)
Start printing.
Note
• Y ou can skip steps 6 and 7 if a barcode has been printed on the roll paper and you have activated
automatic detection of the remaining roll. The paper type and amount of paper left are automatically
detected. The barcode will automatically be cut of f after it has been read.
• Y ou can skip step 6 if you have deactivated automatic detection of the remaining roll paper .
• If you have deactivated width detection, you will need to enter the roll width after choosing the paper
type in step 5. ( → P .50)
• If you select a type of paper for which width detection is Off when detection of the remaining roll paper is
also Off , you will need to advance the paper manually to the starting position for printing. ( → P .136)
• For details on supported sizes and types of rolls, see “Paper Sizes” or the Paper Reference Guide .
( → P .101) ( → P .96)
• When printing on rolls after printing on sheets, if the lit paper selection lamp does not switch from the
Cut Sheet lamp to the Roll Media lamp , press the Feeder Selection button.
Important
• After changing rolls, clean the Platen . ( → P .538 )
Basic Printing W orkow 85
To Next Page
Loading...
