CAPINTEC, INC. CAPTUS
®
600
p-2 PREFACE November 07
• Suitable for CONTINUOUS OPERATION.
• NOT suitable for use in an OXYGEN or a FLAMMABLE ENVIRONMENT.
ELECTROMAGNETIC INTERFERENCE POTENTIAL
This equipment complies fully with interference immunity requirements of the standard EN
60601-1-2 “Medical electrical equipment: Part 1: General safety requirements; 2.
Supplementary standard: Electromagnetic compatibility”.
This equipment generates radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to nearby devices.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference, the user is encouraged to try to correct the
interference by one of the following measures:
• Increase the separation between the equipment and the affected device.
• Plug the unit into an outlet on a circuit different from that which the affected device is
connected.
If this fails to correct the problem, please contact Capintec’s Authorized Service Center.
INSTALLATION
Your system has been shipped from the factory pre-configured and fully tested. Installation
consists of placing the components on the stand and securing them in place. Detailed
installation and assembly instructions are provided in the CAPTUS
®
600 Unpacking and
Assembly Instructions.
IMPORTANT SAFETY INFORMATION
The CAPTUS
®
600 measurement system has been carefully designed to give you years of
safe and reliable performance. As with all electrical equipment, however, there are basic
precautions you must observe to avoid injuring yourself, the patient or damaging the
equipment.
• Follow the unpacking and assembly instructions document, and read this manual
carefully before using this equipment. Be sure to save all provided documents for
future reference.
• Understand all
warning and caution labels as explained in CHAPTER 1: SAFETY
chapter before operating this equipment.
To Next Page
Loading...