Capintec CAPTUS 600 - User Key Assignment

CAPINTEC, INC. CAPTUS
®
600
USER KEY ASSIGNMENT
USER keys are active in the graphic display for Wipe Test and MCA. If a USER Key has a
nuclide assigned to it, it works the same as a Pre-Set Nuclide key (e.g. Tc99m key).
To set up USER keys, from the Wipe and MCA Setup menu, press 2 to select USER KEY
ASSIGNMENT.
Figure 12-12 will appear.
13:06
ASSIGN NUCLIDE TO USER KEY #1
UKEY
DONE OK
Figure 12-12
Press the F1 [UKEY] key to toggle between the various USER keys. When the proper USER
key is shown, press the F4 [OK] key.
Figure 12-13 will appear showing the current
assignment of the selected USER key. “NONE” will be displayed if no assignment has been
made. In the example below, Co58 has been assigned to USER key #1.
13:06
USER KEY #1 ASSIGNED TO CO58
CHANGE ASSIGNMENT? (Y OR N)
Figure 12-13
If the assignment is correct, press N.
Figure 12-12 will re-appear.
To change the assignment, press Y.
Figure 12-14 will appear.
November 07 WIPE TEST SETUP 12-9