Capintec CAPTUS 600 - HOME Key; Changing from PROBE to WELL Functions; Changing from WELL to PROBE Functions; Contrast

CAPINTEC, INC. CAPTUS
®
600
HOME Key
Pressing the HOME key when performing a Probe function returns the CAPTUS
®
600 to the
Probe Screen (
Figure 3-3).
Pressing the HOME key when performing a Well function returns the CAPTUS
®
600 to the
Well Screen (
Figure 3-4).
Note: If, for any reason, you need to abort a CAPTUS
®
600 measurement or procedure,
press the HOME key. As a rule, however, there will be a “soft” [ABORT] or [EXIT]
key, or you can use the Backspace key to exit or abort from a procedure.
Changing from PROBE to WELL Functions
To perform a Well function after performing a Probe function, press HOME and then press
the WELL key.
Note: Even if you are using the Probe as a Well, you still press the WELL key for
measurements of wipe, urine, and blood samples.
Changing from WELL to PROBE Functions
To perform a Probe function after performing a Well function, press HOME and then press
the PROBE key.
CONTRAST
Located on the back panel, a control knob used to adjust the visual contrast of the
information on the liquid crystal display screen.
SCREEN DIMMER
When the CAPTUS
®
600 system is on, but the keyboard has not been used for a few
minutes, the back-lit screen suddenly becomes dimmer. As soon as you press a key, the
screen returns to its normal bright display, but the key's function is
not performed.
3-4 GENERAL OPERATING OVERVIEW November 07