CAPINTEC, INC. CAPTUS
®
600
CHAPTER 3
GENERAL OPERATING OVERVIEW
TURN ON SYSTEM
Locate the black on/off switch, which is on the back panel of the CAPTUS
®
600 at the right
side. To turn the system on, push the switch up toward the white vertical line; to turn the
system off, push the switch down toward the white circle.
Note: Make sure that the CAPTUS
®
600 is turned on for at least 30 minutes before
performing any measurement functions. If the device is not thoroughly warmed up,
measurements may not be accurate.
Note: It is recommended that you leave the system turned ON all the time.
When you first turn the system on, the Startup Screen (Figure 3-1) appears on the display.
14:32
THYROID UPTAKE SYSTEM
CAPTUS™-600
REV X.XX
COPYRIGHT 1994 ALL RIGHTS RESERVED
CAPINTEC, INC. NJ USA
Press Any Key to Continue
Figure 3-1
Press any key to continue.
LOG-ON PASSWORD
A password is required to gain access to the program.
The Log-on password screen will appear as shown in
Figure 3-2.
November 07 GENERAL OPERATING OVERVIEW 3-1
To Next Page
Loading...