CipherLab 1663 Series - Direct USB Virtual COM; Activate USB Virtual COM; Avtivate USB Virtual COM_CDC; Inter-Function Delay

95
Update
Chapter 2 Selectin
g
Output Interface
2.7 DIRECT USB VIRTUAL COM
1663 supports “ Direct” USB Virtual COM int erface for m em ory m ode. Use the provided
USB cable t o connect 1663 t o the USB port of PC. You m ay run HyperTerm inal.exe on a
com puter t o view and capt ure t he scanned data being transm itt ed to t he com puter. Refer
to
1.2.2 Mem ory Mode.
2.7.1 ACTIVATE USB VIRTUAL COM
*
Activate Direct USB
Virtual COM
Not e: I f using USB Virtual COM for t he first tim e, install it s driver from t he CD- ROM.
Driver version 5.4 or lat er is required. Please rem ove older versions before
installing new ones!
2.7.2 AVTIVATE USB VIRTUAL COM_CDC
*
Activate Direct USB
Virtual COM_CDC
Not e: I f using USB Virt ual COM for t he first tim e, inst all it s driver from the CD-ROM.
2.7.3 INTER-FUNCTION DELAY
By default, the int er- funct ion delay is set t o zero. Specify a value, ranging from 0 t o 254
in unit s of m illiseconds, t o m atch the com puter response tim e of t he keyboard interface.
Such delay t im e is insert ed bet ween every funct ion code (0x01 ~ 0x1F) being
transm it t ed. The longer the delay t ime is, t he slower the transm ission speed will be.
Inter-Function
Delay… (*0~254)
1) Read t he barcode above to specify t he inter-function delay.
2) Read t he “
Decim al Value” barcode on page 219 for the desired inter- funct ion delay (in
m illiseconds) .
3) Read t he “ Validat e” barcode on t he sam e page t o com plet e t his set t ing.