CipherLab 1663 Series - Bluetooth SPP Master; Activate Bluetooth SPP Master Mode; Bluet Oot H SPP Mast er

70
Enter Setup
1663 Barcode Scanner User Guide
2.3 BLUETOOTH
®
SPP MASTER
As a SPP m aster device, the scanner will be able t o resum e connection wit h t he host
upon powering on again, as long as the host applicat ion is running. I f the scanner fails to
resum e connect ion, it will try every 5 seconds to re- connect to t he host unless you read
the “Reset Connect ion” or “Restore Syst em Defaults” barcode.
For Bluetooth
®
SPP Master, refer
3.2.2 Configure Related Sett ings for relat ed connection
sett ings.
Not e: I n SPP Master Mode, scanner has to connect within the specified period of tim e ( 2
m inut es by default) . During the connect ion, t he scanner will ent er into idle m ode
to save power. I t will autom atically t urn off when the t ime is up. Refer to
1.1.3
Aut o Power Off & Power- Saving
.
2.3.1 ACTIVATE BLUETOOTH
®
SPP MASTER MODE
This is SPP Master Mode.
Activate Bluetooth
®
SPP, Master Mode
How to connect with the target device?
Produce two set up barcodes for t he target SPP slave device, just like what we do for 3610.
 “ Set Connect ion”
 “ MAC I D”
Not e: The “ MAC I D” barcode m ust have a prefix of two characters, either “ 0x” or “0X” ,
followed by the real MAC address of the t arget device.
Usage:
1) Read the “Activat e Bluet ooth
®
SPP, Mast er Mode” barcode above and barcodes for connect ion
set t ings, such as authenticat ion and preset PI N. Skip this step if no connection sett ings are
desired.
2) Read t he “Set Connect ion” and “ MAC I D” barcodes. The scanner will respond with one beep
upon reading each of the barcodes.
Set Connection
P
refix “0X” to target MAC address