CipherLab 1663 Series - Default Settings; Save User Settings as Defaults; Restore User Defaults; Restore System Defaults

12
Enter Setup
1663 Barcode Scanner User Guide
DEFAULT SETTINGS
SAVE USER SETTINGS AS DEFAULTS
For the scanner to keep the cust om ized sett ings as user defaults, you m ust read t he
“ Save as User Defaults” barcode. This is a norm al set up barcode, and the scanner will
respond wit h t wo beeps ( low- high tone) .
 After reading t he “ Update” barcode, the current sett ings will be saved as user
default s.
S
ave as User
Defaults
RESTORE USER DEFAULTS
For the scanner to restore the user defaults, which you have saved earlier, you m ust
read t he “ Rest ore User Defaults” barcode. This is a norm al set up barcode, and t he
scanner will respond wit h two beeps (low-high tone) .
 After reading t he “Update” barcode, all the param et ers of the scanner will ret urn t o
their custom ized values.
Restore User
Defaults
RESTORE SYSTEM DEFAULTS
For the scanner t o rest ore the fact ory defaults, read the “Restore System Defaults”
barcode. This is a norm al set up barcode, and the scanner will respond with two beeps
(low- high tone). After reading t he “ Update” barcode, all the param et ers of the scanner
will ret urn to their default values. The current connection record will be cleared as well.
Refer to
1.17.1 Restore Syst em Defaults for t he key combinat ion used to rest ore default s
during operat ion.
For 3610 to restore factory defaults, refer to
3610 Set up Barcodes & Serial Com m ands.
Restore System
Defaults
Not e: The system default value (if there is one) for each setting is indicat ed by an
asterisk “ * ” .