41
Update
Chapter 1
Understandin
he Barcode Scanner
1.8 SCANNING TIMEOUT
Specify t he scanning tim e int erval (1~ 254 sec.; 0= Disable) when the scan m ode is set
to any of the following –
Laser m ode
Auto Off m ode
Auto Power Off m ode
Aim ing m ode
Scanner Time-out
after 0~254 se
.
(*10)
1) Read t he barcode above to specify the tim e interval in seconds before t he scan
engine tim es out .
2) Read t he “
Decimal Value” barcode on page 219. For exam ple, read “1” and “5” for t he
scanner to shut down autom at ically aft er being idle for 15 seconds.
3) Read t he “ Validat e” barcode on t he sam e page t o com plet e t his set t ing.
To Next Page
Loading...
