55
Update
I n order t o establish a proper connection bet ween host computer and t he scanner, we
suggest following t hese inst ruct ions –
1) I nst all battery and hold down the [ Power/ Delet e] key for 2 seconds t o t urn on the
scanner.
2) Read t he “ Ent er Set up” barcode t o enter the configuration mode.
3) Read t he associated barcodes to activate t he desired interface.
See t he following sections for out put interfaces support ed.
4) Read t he barcodes for related set t ings.
5) Read t he “ Update” barcode to exit the configurat ion m ode.
6) Turn on host com puter or laptop and est ablish a WPAN connection with the scanner.
Refer to
Chapt er 3 – Setting up a WPAN Connect ion.
Not e: (1) By default, the output interface is set t o “ Bluet oot h
®
HI D”.
(2) When set t o Mem ory Mode and connect ed to com puter via the Direct USB
cable, the default out put interface becom es “ Direct USB Virtual COM” .
IN THIS CHAPTER
2.1 Bluet oot h® HI D......................................................... 56
2.2 Bluet oot h
®
SPP Slave ................................................. 68
2.3 Bluet oot h® SPP Master .............................................. 70
2.4 USB HI D via 3610 ...................................................... 73
2.5 USB Virtual COM via 3610 ........................................... 83
2.6 Direct USB HI D.......................................................... 85
2.7 Direct USB Virtual COM............................................... 95
Chapter 2
SELECTING OUTPUT INTERFACE
To Next Page
Loading...
