71
Update
Chapter 2
Selectin
Output Interface
Not e: Read t he “ Set Connect ion” barcode first , and then t he “MAC I D” barcode wit hin 10
seconds.
I nst ead of producing the “MAC I D” barcode, you m ay read t he set up barcodes for entering the MAC
address.
Read the “Abort ” barcode to cancel t he operat ion at any t ime while reading setup barcodes for
the MAC address. I f the MAC address has not been com plet ed yet , reading t he “ Validat e”
barcode can cancel the operat ion as well.
Enter MAC ID in
Hexadecimal…
Usage:
1) Read t he bar code above.
2) Read t he “
Hexadecim al Value” barcode on page 220 for the desired MAC address.
3) Read t he “Validat e” barcode on t he sam e page to com plet e this setting.
Exit SPP Master Mode
To st op such re-connect ion, read “Reset Connect ion” or “Rest ore Syst em Default s” barcode so that
the current connect ion record ( = MAC I D) will be cleared. Then, the scanner will rest art itself
automatically. Go through the process in
3.2.3 Connect to Dongle to establish a new WPAN
connection.
Reset Connection
2.3.2 INTER-FUNCTION DELAY
By default, the int er- funct ion delay is set t o zero. Specify a value, ranging from 0 t o 254
in unit s of m illiseconds, t o m atch the com puter response tim e of t he keyboard interface.
Such delay t im e is insert ed bet ween every funct ion code (0x01 ~ 0x1F) being
transm it t ed. The longer the delay t ime is, t he slower the transm ission speed will be.
Inter-Function
Delay… (*0~254)
1) Read t he barcode above to specify t he inter-function delay.
2) Read t he “
Decim al Value” barcode on page 219 for the desired inter- funct ion delay (in
m illiseconds) .
3) Read t he “ Validat e” barcode on t he sam e page t o com plet e t his set t ing.
To Next Page
Loading...
