CipherLab 1663 Series - Create One-Scan Setup Barcodes

19
Update
Quick Start
CREATE ONE-SCAN SETUP BARCODES
The fact is m ost of the scanner param et ers require only one read for set t ing new values.
To facilit ate configuring the scanner, you m ay create One- Scan setup barcodes for use.
The requirem ents of a One-Scan setup barcode are:
 a prefix of the “# @” charact ers
 t he six digit s of com m and param et ers
 a suffix of t he “ # ” charact er
For exam ple, the scanner needs the reading of three set up barcodes for t he com m and
param et er “109952” to take effect :
Enter Setup
List Page 3
Update
Now, it requires only one read:
One-Scan Setup Barcode for
109952
Not e: The scanner will restart aut om at ically upon reading t he One- Scan set up barcode
for ( 1) changing t he int erface or (2) set t ing m emory m ode, enable or disable. I t
will respond wit h a long beep and it s LED will com e on-off.