28
Enter Setup
1663 Barcode Scanner User Guide
Dat a” barcode below.
1663 can send dat a via “ Direct USB” int erface once the com put er has found the USB connect ion.
Refer to
1.14 Use Direct USB Cable. Because the tim e- out value is set to 0 by default , connect the
cable before having the scanner read the “Send Dat a” barcode. Otherwise, t he scanner will t ry to
tem porarily resum e the previous WPAN connect ion with the host, if t here is any.
During t ransm ission of dat a collect ed in m em ory m ode, if t he transm ission fails, the scanner will
flash red (On/ Off rat io 0.2 s: 0.2 s) after responding with two short beeps ( high- low tone) and go
back to previous working m ode. Press trigger or power key to st op flashing.
Send Data
Send Data Time-out
I f a t im e- out value other than zero is given, it will first try to send data via “ Direct USB” int erface
wit hin the specified period of tim e. Connect the cable before it times out. When t he att em pt fails, it
will try to tem porarily resum e the prev ious WPAN connect ion with the host, if there is any.
I f 1663 has never been connect ed t o t he host cordless, it will not be able to send data until it is
connected using the Direct USB cable!
Send Data Time-Out
fter 0~15 sec.
(*0)
Clear Data & Confirm
Even though data has been sent to the host, t he flash memory is st ill occupied unless you erase
the m em ory by reading two barcodes – “Clear Dat a” and “Confirm ” .
1) Read t he “Clear Data” barcode to clear the flash m em ory.
2) Read t he “Confirm ” barcode to confirm the act ion.
Clear Data
Confirm
1.2.3 FREE MEMORY
Upon m em ory m ode, you can scan t he barcode below t o show the available capacit y of
the flash mem ory in percentage term s.
Spare memory
To Next Page
Loading...
