CipherLab 1663 Series - 3610 Serial Command Table

212
Enter Setup
1663 Barcode Scanner User Guide
3610 SERIAL COMMAND TABLE
Config<CR>
Purpose To configure 3610.
Here is the setup barcode for this serial com m and:
Config
Rem arks A list of the current set tings will be displayed. Run HyperTerm inal.exe on your
comput er and change the sett ings one by one.
DefaultSetting<CR>
Purpose To restore the default sett ings.
Here is the setup barcode for this serial com m and:
DefaultSetting
SingleConnection<CR>
Purpose To allow only one scanner connecting to 3610.
Here is the setup barcode for this serial com m and:
SingleConnection
MultiConnection<CR>
Purpose To allow up to seven scanners connect ing to 3610.
Here is the setup barcode for this serial com m and:
MultiConnection
UseOnePortforAll<CR>
Purpose To use one Virtual COM port for all whenever connecting 3610 to PC via USB. This
set t ing requires to connect one 3610 at a t ime, and will facilit at e configuring m ult iple
3610 via t he sam e Virt ual COM port (for adm inistrators’ or factory use) .
Here is the setup barcode for this serial com m and:
UseOnePortforAll