197
Update
Chapter 6
Applyin
Formats for Data Editin
6.6 PROGRAMMING EXAMPLES
6.6.1 EXAMPLE I
Extract data from the 10th character to the 19th character...
The edit ing form at should be configured as follows:
1) Read the “Enter Set up” barcode to ent er the Configuration Mode.
2) Read the “Configure Format 1” barcode.
3) Read the “Clear All” and “ Code 128” barcodes for applicable code type.
4) Read the “Three Fields” barcode.
5) Read the “Divide Field 1 by Lengt h” barcode, and set length t o 9.
Field 1 dat a st arts from the 1
st
character to the 9
th
character.
6) Read the “Divide Field 2 by Lengt h” barcode, and set length t o 10.
Field 2 dat a st art s from the 10
th
character to the 19
th
character.
7) Read the “St art (Program m ing) ” barcode to program the transm ission sequence.
8) Read the “Field 2” barcode.
9) Read the “End” barcode to com plet e the transm ission sequence setting.
10) Read the “End Program m ing Form at ” barcode to complet e the set t ing of Editing Form at 1.
11) Read the “Enable Form at 1” barcode to apply Editing Form at 1 t o Code 128.
12) Read the “Update” barcode to exit the Configuration Mode.
To Next Page
Loading...
