CipherLab 1663 Series - Page 39

27
Update
Chapter 1 Understandin
g
t
he Barcode Scanner
Enable
*Disable
Warning: No real- t im e connection is allowed unless t he m em ory m ode is disabled.
Memory Data Delay
You m ay set a delay bet ween each dat a record while transm itting dat a back to t he host.
*None
250 ms
500 ms
1 sec
2 sec
3 sec
5 sec
8 sec
Send Data
When t he mem ory is used up, the scanner will respond w it h t wo short beeps (high-low tone) as a
warning. I t is advised to send data to t he host im m ediately by having the scanner read the “Send