Cisco 7925G Administration Guide

Configuration ReferenceDescriptionFeature
For more information, see:
•
Cisco Unified Communications
Manager Features and Services Guide,
“Do Not Disturb” chapter
•
Cisco Unified Communications
Manager Administration Guide
When DND is turned on, no audible rings occur during the
ringing-in state of a call or no audible or visual notifications
of any type occur.
You can configure the phone to have a softkey template with
a DND softkey or a phone-button template.
DND is available in Cisco Unified Communications
Manager 6.0 or later.
Note
The following DND parameters are configurable in Cisco
Unified Communications Manager Administration:
DND
This check box allows you to enable DND on a
per-phone basis. Use Cisco Unified Communications
Manager Administration > Device > Phone > Phone
Configuration.
DND Option
Choose “Call Reject” (to turn off all audible and visual
notifications), or “Ringer Off” (to turn off only the
ringer). DND Option appears on both the Common
Phone Profile window and the Phone Configuration
window (Phone Configuration window value takes
precedence).
DND Incoming Call Alert
Choose the type of alert to play, if any, on a phone for
incoming calls when DND is active. This parameter is
located on both the Common Phone Profile window and
the Phone Configuration window (Phone Configuration
window value takes precedence).
BLF Status Depicts DND
Enables DND status to override busy/idle state.
DND
No configuration required.Enables the WLAN firmware to meet the 2015 European
compliance regulations.
EU Regulatory
Compliance
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
155
Features, Templates, Services, and Users
Telephony Features Available

Cisco 7925G Specifications

General

Keypad number of keys	12
Display diagonal	2 \
Display resolution	176 x 220 pixels
Call waiting	Yes
Lines quantity	6 lines
Voice codecs	G.711a, G.722, G.729a, iLBC
Security algorithms	128-bit WEP, SSL/TLS, WPA
Supported network protocols	DHCP, TFTP, DNS, SCCP, SRST
Input voltage	100 - 240 V
Dimensions (WxDxH)	52 x 20 x 127 mm
Minimum system requirements	Cisco Unified Communications Manager 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, 7.0 + Cisco Unified Communications Manager Express 4.3 +
Input frequency	50/60 Hz
Storage temperature (T-T)	-30 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Product type	IP Phone
Product color	Gray
Safety	UL 60950, CSA 22.2 No.60950, EN 60950, IEC 60950, AS/NZS 60950, IEC 60529 (IP 54)
Certification	47 CFR 15 B ICES-003 B EN 55022 B AS/NZS CISPR 22 B CISPR 22 B VCCI B EN 61000-3-2 EN 61000-3-3 KN 22 EN 55024 EN 50082-1 EN 61000-6-1 EN 300386 EN 60601-1-2 KN
Compliance industry standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.1X, IEEE 802.11e

Weight and Dimensions

Weight	138 g