Send documentation comments to mdsfeedback-doc@cisco.com
11-5
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
OL-9285-05
Chapter 11 Troubleshooting VSANs, Domains, and FSPF
VSAN Issues
vsan is 2
Beacon is turned off
Trunk vsans (allowed active) (1-3,5)
Trunk vsans (operational) (1-3,5)
Trunk vsans (up) (2-3,5)
Trunk vsans (isolated) (1)
Trunk vsans (initializing) ()
475 frames input, 8982 bytes, 0 discards
0 runts, 0 jabber, 0 too long, 0 too short
0 input errors, 0 CRC, 3 invalid transmission words
0 address id, 0 delimiter
0 EOF abort, 0 fragmented, 0 unknown class
514 frames output, 7509 bytes, 16777216 discards
Received 30 OLS, 21 LRR, 18 NOS, 53 loop inits
Transmitted 68 OLS, 25 LRR, 28 NOS, 32 loop inits
Step 4 If the trunk is not configured for the VSAN, use the interface command and then the switchport trunk
allowed vsan command in interface mode to add the VSAN to the allowed VSAN list for the interface
that connects the host and storage devices.
E Port Is Isolated in a VSAN
Symptom E port is isolated in a VSAN.
Table 11-2 xE Port Is Isolated in a VSAN
Symptom Possible Cause Solution
E port is isolated in a
VSAN.
E port connecting to the remote switch
is isolated.
Verify the VSAN. See the “Resolving an Isolated E Port
Using Fabric Manager” section on page 11-6 or the
“Resolving an Isolated E Port Using Fabric Manager”
section on page 11-6.
TE port connecting to the remote
switch is isolated.
See the “Resolving an Isolated ISL Using Fabric Manager”
section on page 11-7 or the “Resolving an Isolated ISL
Using the CLI” section on page 11-7
Fabric timers misconfigured. Use caution when changing fabric timers. See the
“Resolving Fabric Timer Issues Using Fabric Manager”
section on page 11-9 or the “Resolving Fabric Timer Issues
Using the CLI” section on page 11-9.
Port parameters misconfigured. See the “Common Problems with Port Interfaces” section
on page 8-13.
Zoning mismatch. See Chapter 14, “Troubleshooting Zones and Zone Sets.”
To Next Page
Loading...
Need help?
General