Send documentation comments to mdsfeedback-doc@cisco.com
13-16
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
OL-9285-05
Chapter 13 Troubleshooting IVR
Troubleshooting the IVR Wizard
Warning: Not All Switches Are IVR NAT Capable or Are Unmanageable
Symptom Warning: Not all switches are IVR NAT capable or are unmanageable.
Error: The Following Switches Do Not Have Unique Domain IDs
Symptom The following switches do not have unique domain IDs.
Table 13-15 Not All Switches Are IVR NAT Capable or Are Unmanageable
Symptom Possible Cause Solution
Warning: Not all
switches are IVR
NAT capable or are
unmanageable.
One or more switches in the fabric
are not running Cisco MDS SAN-OS
Release 2.1(1a) or later.
Upgrade to the Cisco SAN-OS release required for the IVR
features you want to use. See Table 13-1 and Chapter 2,
“Troubleshooting Installs, Upgrades, and Reboots.”
One or more switches in the fabric
cannot communicate with Fabric
Manager or are not Cisco SAN-OS
switches.
Determine if any of the problem switches are required in the
IVR topology. If not, ignore this message and proceed with
the IVR configuration. If they are required, choose Switches
and check the Status column to determine the cause and
address the problem.
Table 13-16 The Following Switches Do Not Have Unique Domain IDs
Symptom Possible Cause Solution
The following
switches do not have
unique domain IDs.
The listed switches have duplicate
domain IDs in two or more VSANs in
your proposed IVR configuration.
Choose Fabricxx > All VSANS > Domain Manager and set
the ConfigDomainId to a unique number and set the Config
Type drop-down menu to static in Fabric Manager. Set the
Restart drop-down menu to disruptive and click Apply
Changes. This triggers a disruptive restart to make the
running domain ID match the configured domain ID.
Use IVR NAT. This may require upgrading to Cisco MDS
SAN-OS Release 2.1(1a) or later.
To Next Page
Loading...
Need help?
General