Cisco 9134 - MDS Multilayer Fabric Switch User Manual

Send documentation comments to mdsfeedback-doc@cisco.com
25-7
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
OL-9285-05
Chapter 25 Troubleshooting Call Home
Call Home Issues
Configuring Call Home Contact Information Using Fabric Manager
To assign the contact information, follow these steps:
Step 1 Choose Switches > Events > Call Home in the Physical Attributes pane.
Step 2 Click the General tab and then assign contact information. You must enter an e-mail address that
identifies the source of Call Home notifications.
Step 3 Click Apply Changes.
Configuring Call Home Contact Information Using the CLI
To assign the contact information, follow these steps:
Command Purpose
Step 1
switch# config t
Enters configuration mode.
Step 2
switch# snmp-server contact
personname@companyname.com
Configures the SNMP contact name.
Step 3
switch(config)# callhome
switch(config-callhome)#
Enters the Call Home configuration submode.
Step 4
switch(config-callhome)# email-contact
username@company.com
Assigns the customer’s e-mail address. Up to 128
alphanumeric characters are accepted in e-mail
address format.
Note You can use any valid e-mail address.
You cannot use spaces.

Cisco 9134 - MDS Multilayer Fabric Switch Specifications

General

Brand	Cisco
Model	9134 - MDS Multilayer Fabric Switch
Category	Switch
Language	English