EasyManuals Logo

Cisco 9134 - MDS Multilayer Fabric Switch User Manual

Cisco 9134 - MDS Multilayer Fabric Switch
560 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #232 background imageLoading...
Page #232 background image
Send documentation comments to mdsfeedback-doc@cisco.com
11-12
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
OL-9285-05
Chapter 11 Troubleshooting VSANs, Domains, and FSPF
Dynamic Port VSAN Membership Issues
DPVM Database Not Distributed
Symptom DPVM databases are not distributed.
DPVM Autolearn Not Working
The DPVM autolearn feature allows you to automatically populate the DPVM configuration database
with all devices currently in the fabric. This feature is best used when you first turn on DPVM in a stable
fabric. Once the devices are learned, you disable autolearning to populate the configuration database
with these autolearned entries.
When you add a new device, it is a best practice to manually add that device to the DPVM configuration
database. If you turn on autolearning for a new device, you may add other devices that you did not intend
to add.
Symptom DPVM autolearn does not work or is not getting enabled.
Note When DPVM distribution is enabled, you must do an explicit commit for DPVM activate and autolearn
to take effect.
Table 11-4 DPVM Database Not Distributed
Symptom Possible Cause Solution
DPVM databases are
not distributed.
DPVM distribution has not been
enabled on the local switch.
Choose Fabricxx > All VSANs > DPVM and select the
CFS tab. Check the Global field in Fabric Manager or use
the show dpvm status CLI command to verify that DPVM
distribution is not enabled. Set the Global field to enable
in Fabric Manager and then click Apply Changes or use
the dpvm distribute CLI command to enable DPVM.
DPVM distribution has not been
enabled on one or more remote
switches.
Table 11-5 DPVM Autolearn Not Working
Symptom Possible Cause Solution
DPVM autolearn does
not work or is not
getting enabled.
DPVM active database may be absent. Choose Fabricxx > All VSANs > DPVM and select the
Active Database tab in Fabric Manager or use the show
dpvm database CLI command to verify that DPVM is not
enabled. Select the Actions tab and set the Action field to
activate in Fabric Manager and then click Apply Changes
or use the dpvm activate and dpvm commit CLI
commands to create the DPVM active database.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 9134 - MDS Multilayer Fabric Switch and is the answer not in the manual?

Cisco 9134 - MDS Multilayer Fabric Switch Specifications

General IconGeneral
BrandCisco
Model9134 - MDS Multilayer Fabric Switch
CategorySwitch
LanguageEnglish

Related product manuals