Send documentation comments to mdsfeedback-doc@cisco.com
13-17
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
OL-9285-05
Chapter 13 Troubleshooting IVR
Troubleshooting the IVR Wizard
Error: Pending Action/ Pending Commits
Symptom Pending action on pending commit error displays.
Error: Fabric Is Changing. Please Retry the Request Later
This error may occur if there are different versions of Cisco SAN-OS on the IVR-enabled switches. You
should upgrade all IVR-enabled switches to the same version of Cisco SAN-OS.
Table 13-17 Pending Action/Pending Commits
Symptom Possible Cause Solution
Pending action on
pending commit error
displays.
A separate IVR configuration change
that was not committed.
IVR has pending changes that were not committed. Choose
Fabricxx > All VSANS > IVR and select the CFS tab in
Fabric Manager. Set the View Config As drop-down menu to
pending and verify the pending configuration changes. Set
the ConfigAction drop-down menu to commit to save these
changes or abort to discard the changes. Click Apply
Changes.
The IVR CFS session was not
unlocked after the last commit.
Choose Fabricxx > All VSANS > IVR and select the CFS
tab in Fabric Manager. Set the ConfigAction drop-down
menu to clear to remove the session lock. Click Apply
Changes.
To Next Page
Loading...
Need help?
General