EasyManuals Logo

Cisco 9134 - MDS Multilayer Fabric Switch User Manual

Cisco 9134 - MDS Multilayer Fabric Switch
560 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #231 background imageLoading...
Page #231 background image
Send documentation comments to mdsfeedback-doc@cisco.com
11-11
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
OL-9285-05
Chapter 11 Troubleshooting VSANs, Domains, and FSPF
Dynamic Port VSAN Membership Issues
Step 4 Select the Active Database tab.
Step 5 Select Pending from the Compare To drop-down menu. You see a dialog box listing any differences
between the active DPVM database and the pending database.
Step 6 Select the CFS tab and set Config Action to commit if there are any pending changes that you want to
save. Click Apply Changes.
Step 7 Select the Actions tab and select activate from the Actions drop-down menu to activate the database.
Click Apply Changes.
Troubleshooting DPVM Using the CLI
To troubleshoot DPVM using the CLI, follow these steps:
Step 1 Use the show dpvm command in EXEC mode to verify that CFS distribution is enabled for DPVM.
Optionally, use the dpvm distribute command in config mode to enable CFS distribution if required.
Step 2 Use the show dpvm status command in EXEC mode to verify that autolearning is disabled.
Optionally, use the no dpvm auto-learn command in config mode if you need to disable autolearning
before activating the database.
Step 3 Use the show dpvm pending-diff command in EXEC mode to compare the active and pending
databases.
Optionally use the dpvm commit command in config mode to commit any pending entries to the config
database.
Step 4 Use the dpvm activate command in config mode to activate the database.
DPVM Configuration Not Available
Symptom DPVM configuration is not available on Fabric Manager or CLI.
Table 11-3 DPVM Configuration Not Available
Symptom Possible Cause Solution
DPVM configuration
is not available on
Fabric Manager or
CLI.
DPVM has not been enabled. DPVM must be enabled before it can be configured.
Choose Fabricxx > All VSANs > DPVM and check the
Status field in Fabric Manager or use the show dpvm
status CLI command to verify that DPVM is not enabled.
Set the Status field to enable in Fabric Manager and then
click Apply Changes or use the dpvm enable CLI
command to enable DPVM.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 9134 - MDS Multilayer Fabric Switch and is the answer not in the manual?

Cisco 9134 - MDS Multilayer Fabric Switch Specifications

General IconGeneral
BrandCisco
Model9134 - MDS Multilayer Fabric Switch
CategorySwitch
LanguageEnglish

Related product manuals