EasyManuals Logo

Cisco 9134 - MDS Multilayer Fabric Switch User Manual

Cisco 9134 - MDS Multilayer Fabric Switch
560 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #438 background imageLoading...
Page #438 background image
Send documentation comments to mdsfeedback-doc@cisco.com
20-64
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
OL-9285-05
Chapter 20 Troubleshooting IP Storage Services
iSLB Issues
VRRP Master Overutilized
Symptom VRRP master is overutilized.
iSLB Zone Set Activation Failed
Symptom iSLB zone set activation failed.
Table 20-14 VRRP Master Overutilized
Symptom Possible Cause Solution
VRRP master is
overutilized.
iSCSI interface parameters do not
match the rest of the interfaces in the
VRRP group.
Verify the interface parameters for all interfaces in the
VRRP group.
Or use the show vrrp CLI command to view which
interfaces are in the VRRP group, then use the show
interface iscsi CLI command.
Load metric needs to be adjusted. Raise the load metric.
Use the metric CLI command in iSLB configuration mode.
The default value is 1000.
Table 20-15 iSLB Zone Set Activation Failed
Symptom Possible Cause Solution
iSLB zone set
activation failed.
iSLB auto-zone is enabled but CFS
distribution is not enabled.
Enable CFS distribution for iSLB to share load across
multiple switches.
Use the islb distribute CLI command on each switch in the
fabric.
Zone set activation is not from switch
with IVR and iSLB enabled.
Activate the zone set from a switch that has IVR and iSLB
enabled.
Use the islb zoneset activate CLI command.
Another zone set activation is in
progress.
Only one zoning related action can occur at the same time
(zone, IVR zone, or iSLB zone configuration or activation).
Wait until the zone set activation completes and then retry
the iSLB zone set activation.
Zoning database is locked because a
configuration is pending.
Only one zoning related action can occur at the same time
(zone, IVR zone, or iSLB zone configuration or activation).
Commit the existing configuration change or discard the
changes.
Use the show islb status, islb commit, or islb abort CLI
command to view the status, to commit the changes or to
discard the changes, respectively.
Also, verify that no zone or IVR zone changes are pending.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 9134 - MDS Multilayer Fabric Switch and is the answer not in the manual?

Cisco 9134 - MDS Multilayer Fabric Switch Specifications

General IconGeneral
BrandCisco
Model9134 - MDS Multilayer Fabric Switch
CategorySwitch
LanguageEnglish

Related product manuals