Send documentation comments to mdsfeedback-doc@cisco.com
23-6
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
OL-9285-05
Chapter 23 Troubleshooting SANTap
SANTap Issues
Example 23-7 Display SANTap Remote Virtual Terminal Information
switch# show santap module 2 rvt
RVT Information :
rvt pwwn = 2a:61:00:05:30:00:22:25
rvt nwwn = 2a:62:00:05:30:00:22:25
rvt id = 17
rvt vsan = 4
rvt if_index = 0x1080000
Example 23-8 Display SANTap Remote Virtual Terminal LUN Information
switch# show santap module 2 rvtlun
RVT LUN Information :
rvt pwwn = 2a:61:00:05:30:00:22:25
rvt lun = 0x0
xmap id = 22
rvt id = 17
app pwwn = 22:00:00:20:37:39:b1:00
app lun = 0x0
app vsan = 1
Use the following commands to display more advanced troubleshooting information for SANTap.
• show tech-support
• show santap module 2 tech-support
• show isapi tech-support
• show santap vttbl dvt dvt-pwwn
Messages, Logs and Databases
The following log files and databases can provide helpful information when troubleshooting SANTap
problems.
• Look for SSM_CRIT in Sup syslog messages.
• SANTap logs are available via the show isapi tech-support CLI command. Search for the strings
“Error” and “failed” or “failure.”
• Review FCNS and FLOGI databases, using the show fcns and show flogi CLI commands.
SANTap Issues
This section includes the following topics:
• Host Login Problems, page 23-7
• ITL Problems, page 23-7
• Common Mismatch Problems, page 23-7
To Next Page
Loading...
Need help?
General