Send documentation comments to mdsfeedback-doc@cisco.com
20-63
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
OL-9285-05
Chapter 20 Troubleshooting IP Storage Services
iSLB Issues
iSLB Zones Not Present in Active Zone Set
Symptom iSLB zones not present in active zone set.
Traffic Description After iSLB Commit or Activation of Zone Set
Symptom Traffic description after iSLB commit or activation of zone set (normal, IVR, or iSLB).
Table 20-12 iSLB Zones Not Present in Active Zone Set
Symptom Possible Cause Solution
iSLB zones not
present in active zone
set.
Active zone set not configured. Check if an active zone set is configured. If this is not the
case then create and activate a new zone set for the VSAN
in question. Then use the islb zoneset activate CLI
command to trigger iSLB zoning.
Zone set activation failed. If an active zone set is configured, then check for activation
failures. See the “Traffic Description After iSLB Commit
or Activation of Zone Set” section on page 20-63.
Table 20-13 Traffic Disruption After iSLB Commit or Activation of Zone Set
Symptom Possible Cause Solution
Traffic description
after iSLB commit or
activation of zone set
(normal, IVR, or
iSLB).
An iSLB commit must be done from the
switch that has IVR configured.
Commit the iSLB configuration from a switch that has both
IVR and iSLB enabled.
Use the islb commit CLI command.
Any zone set activation (normal, iSLB,
or IVR) must be done from the switch
that has IVR configured.
Activate the zone set from a switch that has both IVR and
iSLB enabled.
Use the islb zoneset activate CLI command.
To Next Page
Loading...
Need help?
General