EasyManuals Logo

Cisco 9134 - MDS Multilayer Fabric Switch User Manual

Cisco 9134 - MDS Multilayer Fabric Switch
560 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #288 background imageLoading...
Page #288 background image
Send documentation comments to mdsfeedback-doc@cisco.com
14-10
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
OL-9285-05
Chapter 14 Troubleshooting Zones and Zone Sets
Zone and Zone Set Issues
Troubleshooting Zone Activation Using the CLI
To verify the active zone set and active zones using the CLI, follow these steps:
Step 1 Use the show zone analysis active vsan vsan-id command to analyze the active zone set database. Verify
that the formatted size does not exceed the 2048 KB limit shown. If it exceeds the limit, you must remove
some zones or devices within a zone.
switch# show zone analysis active vsan 1
Zoning database analysis vsan 1
Active zoneset: zs1 [*]
Activated at: 08:03:35 UTC Nov 17 2005
Activated by: Local [ GS ]
Default zone policy: Deny
Number of devices zoned in vsan: 0/2 (Unzoned: 2)
Number of zone members resolved: 0/2 (Unresolved: 2)
Num zones: 1
Number of IVR zones: 0
Number of IPS zones: 0
Formattted size: 38 bytes / 2048 Kb
Step 2 Use the show zone analysis vsan vsan-id command to analyze the full zone set database. Verify that the
formatted size does not exceed the 2048 KB limit shown. If it exceeds the limit, you must remove some
zones or devices within a zone.
switch# show zone analysis vsan 1
Zoning database analysis vsan 1
Full zoning database
Last updated at: 15:57:10 IST Feb 20 2006
Last updated by: Local [ CLI ]
Num zonesets: 1
Num zones: 1
Num aliases: 0
Num attribute groups: 0
Formattted size: 36 bytes / 2048 Kb
Unassigned Zones: 1
zone name z1 vsan 1
Step 3 Use the show zoneset active vsan-id command to display the active zones.
switchA# show zoneset active vsan 2
zoneset name ZoneSet1 vsan 2
zone name NewZoneName vsan 2
* pwwn 22:35:00:0c:85:e9:d2:c2
* pwwn 10:00:00:00:c9:32:8b:a8
Step 4 Verify that the needed zones are active.
Step 5 Optionally, use the zoneset name ActiveZonesetName vsan-id command and the member NewZone
command to add the zone to the active zone set in the VSAN.
switch(config)# zoneset name ZoneSet1 vsan 2
switch(config-zoneset)# member NewZoneAdded

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 9134 - MDS Multilayer Fabric Switch and is the answer not in the manual?

Cisco 9134 - MDS Multilayer Fabric Switch Specifications

General IconGeneral
BrandCisco
Model9134 - MDS Multilayer Fabric Switch
CategorySwitch
LanguageEnglish

Related product manuals