Send documentation comments to mdsfeedback-doc@cisco.com
11-23
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
OL-9285-05
Chapter 11 Troubleshooting VSANs, Domains, and FSPF
Domain Issues
Allowed Domain ID List Incorrect After a VSAN Merge
Symptom Allowed domain ID list incorrect after a VSAN merge.
Changes to fcdomain Do Not Take Effect
Symptom Changes to fcdomain do not take effect.
Table 11-15 Allowed Domain ID List Incorrect After a VSAN Merge
Symptom Possible Cause Solution
Allowed domain ID
list incorrect after a
VSAN merge
Domain ID lists not manually updated
before the merge.
Add all domain IDs in the VSAN to the domain ID list.
Choose Fabricxx > VSANxx > Domain Manager >
Allowed and select the Allowed DomainIDs tab to view
the current allowed domain ID list in Fabric Manager.
Choose Fabricxx > VSANxx > Domain Manager and
select the Configuration tab to view the existing domain
IDs for this VSAN. Choose Fabricxx > VSANxx >
Domain Manager > Allowed and select the Allowed
DomainIDs tab to add any missing domain IDs, and then
click Apply Changes. If CFS is enabled, select the CFS
tab and select commit from the ConfigAction drop-down
menu and click Apply Changes.
Or use the show fcdomain domain-list to view the current
allowed domain ID list. Compare this to any other switches
in the VSAN to determine what domain IDs are missing.
Use the fcdomain allowed CLI command to add any
missing domain IDs.
Table 11-16 Changes to fcdomain Do Not Take Effect
Symptom Possible Cause Solution
Changes to fcdomain
do not take effect.
Did not trigger a fabric reconfiguration. Trigger a fabric reconfiguration. Choose Fabricxx >
VSANxx > Domain Manager and select Configuration
tab in Fabric Manager. Select nonDistruptive from the
Restart drop-down menu and click Apply Changes. If CFS
is enabled, then select the CFS tab and select commit from
the ConfigAction drop-down menu and click Apply
Changes.
Or use the fcdomain restart CLI command.
To Next Page
Loading...
Need help?
General