Cisco 9134 - MDS Multilayer Fabric Switch

Send documentation comments to mdsfeedback-doc@cisco.com
25-5
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
OL-9285-05
Chapter 25 Troubleshooting Call Home
Call Home Issues
Step 4 Click Apply Changes.
Configuring an Alert Group Using the CLI
To configure alert groups for a destination profile, follow these steps:
Configuring the Message Level for a Destination Profile Using Fabric Manager
To set the message level for each profile for Call Home, follow these steps:
Step 1 Choose Switches > Events > Call Home and click the Profiles tab in the Information pane.
Step 2 Set a message level for each switch using the drop-down menu in the MsgLevel column.
Step 3 Click Apply Changes to save your changes or click Undo Changes to cancel your changes.
Configuring the Message Level for a Destination Profile Using the CLI
To configure message level settings for destination profiles, follow these steps:
Command Purpose
Step 1
switch# config t
Enters configuration mode.
Step 2
switch(config)# callhome
switch(config-callhome)#
Enters Call Home configuration submode.
Step 3
switch(config-callhome)# destination-profile
test1 alert-group environmental
Configures user-defined destination message
profile (test1) to receive Call Home notifications
for power, fan, and temperature-related events.
switch(config-callhome)# destination-profile
short-txt-destination alert-group
environmental
Optional. Configures predefined short-text
destination message profile to receive Call
Home notifications for power, fan, and
temperature-related events.
Command Purpose
Step 1
switch# config t
Enters configuration mode.
Step 2
switch(config)# callhome
switch(config-callhome)#
Enters Call Home configuration submode.
Step 3
switch(config-callhome)# destination-profile
test message-level 5
Optional. Configures the message level urgency
as 5 and above for the user-defined profile
(test1).
switch(config-callhome)# no
destination-profile oldtest message-level 7
Removes a previously configured urgency level
and reverts it to the default of 0 (all messages are
sent).