Send documentation comments to mdsfeedback-doc@cisco.com
13-9
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
OL-9285-05
Chapter 13 Troubleshooting IVR
IVR Issues
Error Message IVR-3-IVZ_ACTIVATION_FAILED_VSAN: Inter-VSAN zoneset [chars]
activation failed in VSAN [dec].
Explanation
Inter-VSAN zone set activation failed in the VSAN.
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 1.3(1).
Error Message IVR-5-IVZS_ACTIVATION_RETRYING: Inter-VSAN zoneset activation failed
with error [hex] in VSAN [dec]. retrying after [dec] seconds.
Explanation
Inter-VSAN zone set activation failed with VSAN shown in the error message. This
could be an intermittent regular zone set activation error. The activation retried in the number of
seconds shown in the error message.
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 1.3(3).
Error Message IVR-5-IVZS_WAITING_FOR_LOWEST_SWWN: Waiting for lowest switch WWN
Inter-VSAN enabled switch in VSAN [dec].
Explanation
This switch does not have the lowest switch world wide name (sWWN) in the VSAN.
Only the inter-VSAN (IVR) enabled switch with the lowest sWWN can add the IVR zones to the
regular active zone set in a VSAN. This switch is waiting until the IVR switch with the lowest
sWWN adds the IVR zone and reactivates the zone set.
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 2.0(1b).
Symptom IVR zone set activation fails.
Table 13-6 IVR Activation Fails
Symptom Possible Cause Solution
IVR zone set
activation fails.
Overlapping domain IDs. Use static domain IDs to assign unique domain IDs to each
switch in the VSAN or use IVR NAT. Choose Fabricxx >
All VSANs > Domain Manager in Fabric Manager or use
the fcdomain domain domain-id [static | preferred] vsan
vsan-id CLI command
Default zone policy is permit. Choose Zone > IVR > Edit Local Full Zone Database in
Fabric Manager. Right-click the IVR zone set that you want
to activate and select Activate. Check the Create Active
Zone Set if none Present check box or use the force option
with the ivr zoneset activate CLI command.
Default zone policy is deny and no
active zone set present.
No active zone set. No zone set has been activated. See the “Troubleshooting
Zone Set Activation” section on page 14-8 to activate a
zone set on an IVR-enabled switch, or use the force option
when activating the IVR zone set.
To Next Page
Loading...
Need help?
General