Send documentation comments to mdsfeedback-doc@cisco.com
14-3
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
OL-9285-05
Chapter 14 Troubleshooting Zones and Zone Sets
Troubleshooting Checklist
Note To issue commands with the internal keyword, you must have a network-admin group account.
To better manage the zones and zone sets on your switch, you can display zone and zone set information
using the show zone analysis command. (See Example 14-1 through Example 14-3.)
Example 14-1 Full Zoning Analysis
switch# show zone analysis vsan 1
Zoning database analysis vsan 1
Full zoning database
Last updated at: 15:57:10 IST Feb 20 2006
Last updated by: Local [ CLI ]
Num zonesets: 1
Num zones: 1
Num aliases: 0
Num attribute groups: 0
Formattted size: 36 bytes / 2048 Kb
Unassigned Zones: 1
zone name z1 vsan 1
Example 14-2 Active Zoning Database Analysis
switch# show zone analysis active vsan 1
Zoning database analysis vsan 1
Active zoneset: zs1 [*]
Activated at: 08:03:35 UTC Nov 17 2005
Activated by: Local [ GS ]
Default zone policy: Deny
Number of devices zoned in vsan: 0/2 (Unzoned: 2)
Number of zone members resolved: 0/2 (Unresolved: 2)
Num zones: 1
Number of IVR zones: 0
Number of IPS zones: 0
Formattted size: 38 bytes / 2048 Kb
show zoneset active Displays information about the active zone set.
show zone tech-support Gathers relevant zoning information that may be
requested by your customer support representative when
troubleshooting zoning issues.
Table 14-1 Zone Troubleshooting Commands in the CLI (continued)
Command Command Description
To Next Page
Loading...
Need help?
General