Send documentation comments to mdsfeedback-doc@cisco.com
14-22
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
OL-9285-05
Chapter 14 Troubleshooting Zones and Zone Sets
Enhanced Zoning Issues
Problems can occur when the lock is acquired, but not released. In this situation, you cannot configure
zoning on that VSAN. If you are using the CLI, you see error messages when you attempt to enter the
zoning configuration mode.
Troubleshooting CLI commands to use for enhanced zoning issues:
• show zone internal change event-history
• show zone status vsan
• show zone pending-diff
• show zone pending vsan
Symptom Cannot configure zoning.
Table 14-3 Cannot Configure Zoning
Symptom Possible Causes Solutions
Cannot configure
zoning.
Another user on the same switch is holding
the enhanced zoning configuration lock. If
you are using the CLI, you see a message
stating that another session is active.
See the“Resolving Enhanced Zoning Lock Issues with
Fabric Manager” section on page 14-23 or the “Resolving
Enhanced Zoning Lock Issues with the CLI” section on
page 14-23.
Another user on a different switch is
holding the enhanced zoning configuration
lock. If you are using the CLI, you see a
message stating that the lock is currently
busy.
To Next Page
Loading...
Need help?
General