Cisco ProtectLink Web
Web Protection
Cisco RV220W Administration Guide 102
5
• Temporarily bypass Cisco ProtectLink URL Filtering for requested URLs:
URL requests will temporarily bypass URL Filtering and Web Reputation.
This setting could make your network vulnerable to threats.
STEP 2 Click Save to save your settings, or click Cancel to reload the page with the
current settings.
Web Reputation
Use the Cisco ProtectLink Web > Web Protection > Web Reputation page to
enable and configure Web Reputation. When this feature is enabled, Requested
URLs are checked against the set security level and the Trend Micro Web Security
database in real-time. Only URLs that meet the criteria are accessible.
To open this page: In the navigation tree, choose Cisco ProtectLink Web > Web
Protection > Web Reputation.
NOTE This page is available only if you activated your Cisco ProtectLink Web service. See
Getting Started with Cisco ProtectLink Web, page 98.
STEP 1 In the Web Reputation section, check the Enable box to enable this feature.
Uncheck the box to disable it.
STEP 2 In the Security Level section, choose one of these options:
• High—This option blocks a higher number of potentially malicious websites,
but also has a higher incidence of false positives (legitimate sites that are
classified as malicious).
• Medium—This option blocks most potentially malicious websites, and has a
lower incidence of false positives (legitimate sites that are classified as
malicious). This setting is recommended.
• Low: This option blocks fewer potentially malicious websites, and therefore
reduces the risk of false positives.
STEP 3 Click Save to save your settings, or click Cancel to reload the page with the
current settings.
To Next Page
Loading...
Need help?
General
